EN
Find my plan

Install a Travel eSIM on iPhone

A step-by-step walkthrough for Canadian iPhone users: add the plan on Wi-Fi at home, keep your number, and switch data when you land. Based on Apple’s official Settings paths.

These steps follow Apple’s published flow for adding an eSIM (see Set up eSIM on iPhone, 22 October 2026). Labels can vary slightly by iOS version. If a screen does not match, search Settings for “Add eSIM” rather than forcing a menu that is not there.

A traveller holding an iPhone
Licensed still from our self-hosted travel video. See the credits page.

Before You Start

You need an iPhone XS, XS Max, XR or later, unlocked, and on a current iOS. Confirm in Settings > General > About, and in Cellular / Mobile Data. You also need Wi-Fi, the provider’s QR code or app, and a few minutes at home — not at the boarding gate. If you bought the phone in mainland China, Hong Kong or Macao, read Apple’s regional notes first; some units use two physical SIMs instead of eSIM.

US-purchased iPhone 14 and later have no SIM tray. Some later models sold in Canada are also eSIM-only. That does not change the install; it just means a plastic travel SIM is not a fallback.

Preparing bags the day before a flight
Licensed still from our self-hosted travel video. See the credits page.

Add the Plan

  1. Connect to Wi-Fi. Open Settings > Cellular (Mobile Data on some Canadian units).
  2. Tap Add eSIM, or Add Cellular Plan. If the provider’s app supports direct install, you can start there instead of the camera.
  3. Scan the QR code. If you cannot scan, enter the SM-DP+ address and activation code the provider sent.
  4. Wait for the profile to download. Name the line Travel. Do not delete your Canadian line.
  5. When iOS asks which line is default for cellular data, keep the Canadian line for now if the plan starts at first use abroad. If the plan starts at installation, follow the provider’s note — and do not install weeks early.
  6. Turn data roaming off on the Canadian line. Leave the travel line off until you land, unless the provider told you to test at home.

On iPhone 13 and later you can have two eSIMs active. That is useful if your Canadian number is already an eSIM (no physical card) and you add a travel plan beside it. Do not remove the home eSIM to “make room” unless Apple or your carrier has told you the phone is at its stored-profile limit and you have a way to restore the home line.

In the air on the way to a destination
Licensed still from our self-hosted travel video. See the credits page.

When You Land

Open Settings > Cellular. Set Cellular Data to Travel. Confirm the Canadian line is still on for calls and SMS, with data roaming off. If the travel plan requires roaming on its own line to reach a local partner, enable roaming only on Travel. Turn off Allow Cellular Data Switching so the phone does not quietly fall back to Rogers, Bell or Telus.

Make a small test: a map search or a message. If the status bar shows the local carrier and a data icon, you are done. If not, toggle Airplane Mode once, then check APN notes from the provider. More fixes: troubleshooting.

Walking into arrivals
Licensed still from our self-hosted travel video. See the credits page.

After the Trip

Set cellular data back to the Canadian line before you use data in Canada, unless you still have validity and want to spend it. You can leave the travel profile installed and off, or delete it under the line’s name when you are sure you will not top it up. Deleting a profile cannot be undone without the provider issuing a new one, and many travel eSIMs are not portable to a new phone.

Official references: Apple’s setup page and using eSIM while travelling. Our compatibility list, with citations, is at device compatibility.

Flying soon? Compare eSIMs in 30 seconds.

Compare now
Find my plan